Straw.com Home ¤ Crystal Palace Yarns ¤ Free Patterns  ¤  Search this Site ¤ Shop List ¤ Yarn Cards ¤ What's New?  
 


Crystal Palace Yarns
free knit felted hat pattern


Above: Hat before felting

Below: hat after felting
( I've never had knitters laugh when seeing a hat on anyone as much as when this hat is modeled!)

Close up of the felted surface below.


Labrador + Fizz Felted Hat
Easy & Fast to knit using size DAISY 35 DP needles

Materials:
1-50 gr. ball of Fizz (here color 9153, berry parfait)
1-100 gr. balls of Labrador wool (here color 9580, kelim)

2 ends of Labrador and 1 end Fizz are held together to knit the hat. The finished knit is very loose until after felting.

Note: Before beginning hat, divide the ball of Labrador into 2 balls.

To knit the hat:
Using size 35 Double Point Daisy Needles, holding 2 ends of Labrador and one of Fizz, cast on 10 sts on each of 3 DPs [total 30]. Join the round, being careful not to twist the first row when joining.

Knit 3 rounds in St st, knit one round in rev St st (purl side out), then work 7 more rounds in St st.

12th Round: K1, K2tog, repeat to end of round. [20 sts]
Knit 1 round.
14th Round: K1, K2 tog, repeat to end of round.
Continue K1, K2 tog until 9 sts rem. Place 3 sts on each DP needle.

Work each group of 3 sts into fat I-cords on the DPs (forming 3 long I-cords) each approx. 10 inches long.

There will be some holes at the base of the I-cords at the top of the hat. Using a tapestry needle and some Labrador, sew up the holes loosely.

Check the sides of the loosely knit hat, if there are any large holes where you moved from one DP to the next, sew up the hole with the Labrador on your tapestry needle. [Remember, you'll be felting the hat and it will tighten up a lot! See the before and after photos below.]

Put your hat into washing machine with a low water setting and a few hand towels or a bath towel to help rub the wool during felting.  My hat felted nicely in one 5 min. cycle of wash and rinse. I did not need to put in a dryer. Take your hat out after a few minutes to check size and amount of felting. When hat is felted enough, remove it and allow it to dry on a towel.

[Note: If you don't want to have the I-cord 'pigtails' at the top of the hat, just leave them off and decrease at the top of the hat until you are down to only 2 sts and cast off.]

Make a hat on DAISY 35 DPs and send us a photo with your name and someting about how you knit your hat - we'd love to have a Gallery photo to show off your creations.

Below see what a set of DAISY size 35 DPs look like - fun!

 

 

 

 

Copyright 2005 Crystal Palace Yarns/Straw Into Gold, Inc. - We are happy to share this  pattern with knitters. The pattern may be used for non-commercial personal or knitting guild use. It is not to be used in any publication in print nor should it be reproduced in electronic/digital format without permission. Knitting shops carrying CP Yarns Labrador and Fizz are welcome to print and share this pattern with customers of our yarns.

Retail shops in the USA should contact CPY Wholesale for information on purchasing Crystal Palace Yarns and email cpyinfo -at- straw.com (replace the -at- with @)


or write to:
Crystal Palace Yarns, 160 23rd St., Richmond, CA 94804
phone: 510-237-9988,  fax: 510-237-9809

Last revision of this page August 14, 2005


Straw.com Home ¤ Crystal Palace Yarns ¤ Free Patterns  ¤  Search this Site ¤ Shop List ¤ Yarn Cards ¤ What's New?